WANTED Dolmar 120 super project

[Whitty21]

As the title says, looking for anything you have.

I have a running saw but the case is all wallered out and buggered up. Good bottom end would be great, top end is not a big deal. From my understanding the crack's are difference between the 120 and the 120 super, so it would have to be a super. though I am unsure how to confirm the difference between the two...

 

[Frank bierce]

I’ll take a look to see what I have...I may have something.

 

[Frank bierce]

If anyone knows whether the bottom ends are different or not...I have 3 good 120 cases with cranks...possible crank swap? No lunch on a 120 super though.

 

[Whitty21]

I looked into it a while ago. One case side, I wanna say flywheel, and the cranks have different part numbers. I think I had a thread on it on one of the forums.

I have a 120 sitting at here or I would have done it by now

 

[shorthunter]

Stroke is 1mm longer on the Super, I think you can use any of the cases (117, 119, 120)

 

[how57]

As the title says, looking for anything you have.

I have a running saw but the case is all wallered out and buggered up. Good bottom end would be great, top end is not a big deal. From my understanding the crack's are difference between the 120 and the 120 super, so it would have to be a super. though I am unsure how to confirm the difference between the two...

I might have some seals and other stuff. I'd have to dig through all my crap and see.

 

[Whitty21]

bump

 

[Whitty21]

Gunna bump this dino back up. May have time to get the super running again

 

[mgr1]

The difference in the flywheel side case is that the 120 super has the mounting holes from the coil outside the flywheel.

 

[shorthunter]

The difference in the flywheel side case is that the 120 super has the mounting holes from the coil outside the flywheel.

May have that mixed up, the majority of the 120 supers have the coil under the flywheel, the si saws have the coil mounted above the flywheel.

To the OP, you want to start with an si case if you are going to build one. Those coils are much easier to source and you don't have to pull the flywheel, which is a pain in the ass, to replace the coil.

 

[mgr1]

May have that mixed up, the majority of the 120 supers have the coil under the flywheel, the si saws have the coil mounted above the flywheel.

To the OP, you want to start with an si case if you are going to build one. Those coils are much easier to source and you don't have to pull the flywheel, which is a pain in the ass, to replace the coil.

My mistake, you are right. The super has a sem coil.

 

[mgr1]

I have a 119 with bosh coil under flywheel and has even the mounting tab for an external coil.

 

[mgr1]

https://m.ebay.com/itm/USED-SACHS-D...375553?hash=item2cb30a9281:g:1MUAAOSwFV9X0N9r

 

[Whitty21]

https://m.ebay.com/itm/USED-SACHS-D...375553?hash=item2cb30a9281:g:1MUAAOSwFV9X0N9r

That has been up there for awhile. Unfortunately it would be 140 to get it to me, which seems a bit rich to me for what I am getting