- Local time
- 12:28 PM
- User ID
- 522
- Joined
- Jan 12, 2016
- Messages
- 3,951
- Reaction score
- 26,053
- Location
- Iowa City
Someone on this forum asked if I could do something for this old HDA with a broken off HS needle.
First step was to disassemble so I could flush out the flammables.
Next to the tig bench to weld a nut to it... hope it works!
A little shot of penetrating fluid and careful turning... I could probably weld a shaft to it and put it back in.
First step was to disassemble so I could flush out the flammables.
Next to the tig bench to weld a nut to it... hope it works!
A little shot of penetrating fluid and careful turning... I could probably weld a shaft to it and put it back in.