FOUND IT Stihl 090 P&C

[Brewz]

Hi folks
I am planning on building a Stihl 094 which will be an 084 with an 090 top end.

I was looking at Chinese top ends on line and thought I would check to see if someone has anything OEM sitting about looking for a permanent holiday in Australia.

Make 090's great again and see your unwanted piston and cylinder stretched to 147cc

 

[Brewz]

Would be a shame to build it with a Chinese top end

 

[peter92]

Hi folks
I am planning on building a Stihl 094 which will be an 084 with an 090 top end.

I was looking at Chinese top ends on line and thought I would check to see if someone has anything OEM sitting about looking for a permanent holiday in Australia.

Make 090's great again and see your unwanted piston and cylinder stretched to 147cc

see if i can find one some where else for you tony

 

[jb-chainsaws]

I'm intrigued, how will you make this trickery work?! Whatever it is I like it already!

 

[Brewz]

I'm intrigued, how will you make this trickery work?! Whatever it is I like it already!

By hacking at the case until it fits on there

 

[jb-chainsaws]

By hacking at the case until it fits on there

I like it even more now

 

[Brewz]

Well it's not looking good.
I got offered a contra top end from a fella on Facebook but he wants a lot of money for it.

I will order a Chinese top end to get the project rolling

 

[peter92]

Well it's not looking good.
I got offered a contra top end from a fella on Facebook but he wants a lot of money for it.

I will order a Chinese top end to get the project rolling

thats a bummer Tony

 

[Morningman]

I have an aftermarket set up new in box or I have a used oem cylinder

 

[jb-chainsaws]

I have an aftermarket set up new in box or I have a used oem cylinder

@NewToStihl

 

[how57]

@shastonian_74

 

[shastonian_74]

I've got a NOS OEM top end. 66mm.

 

[Bill G]

Well it's not looking good.
I got offered a contra top end from a fella on Facebook but he wants a lot of money for it.

I will order a Chinese top end to get the project rolling

Well the Contra 66mm top ends are tough to locate so there is no doubt it would be expensive. I had 3 NOS ones. I sold one or two. I have used ones here but they have already been run on race saws

 

[Brewz]

Hi Bill

If they already been run, did you wear them out or are they usable?

 

[Bill G]

Hi Bill

If they already been run, did you wear them out or are they usable?

They were run years ago by a retired racer in the 1970's