Solo 665/Dolmar 7910

[Mastermind]

I finally felt well enough to make a video of one of these old Solos. That said......I had to send Dave's 064 back untested. I couldn't start it.

This is two of only three cuts this saw has made. Seems pretty sporty.

 

[exSW]

Oh my!

 

[jmssaws]

Me likey!
I'm in the market for a solo but there not readily had.

 

[Keith Gandy]

Whoa!! That thing has rpm!!

 

[Mastermind]

Whoa!! That thing has rpm!!

We need to get PA Chris to check it.

 

[Simondo]

Mucho Sporty !!!

 

[jmssaws]

Lol

 

[Deets066]

Looks good Randy! I've been wantin one of these bad boys for a while now

 

[wildroamer]

We need to get PA Chris to check it.

It peaked right at 11,276.7900420 rpm's in the cut according to my tricorder.

 

[Keith Gandy]

It peaked right at 11,276.7900420 rpm's in the cut according to my tricorder.

View attachment 18821

 

[Keith Gandy]

My custom ported hearing aid says 12000rpm

 

[Keith Gandy]

She sure aint lazy in the cut!!! Oh we r talkin about a saw!! Sorry!

 

[beaglebriar]

Dayuuuum that runs good!!

 

[Mastermind]

This one has higher timing numbers than any I've done yet.

Ex: 95.5°
Mains: 123°
Secondaries: 126°
In: 81°

 

[Backtroller]

I'm glad to see you're feeling better. Hopefully you'll be healed enough to pull over the 064s soon.

 

[Keith Gandy]

This one has higher timing numbers than any I've done yet.

Ex: 95.5°
Mains: 123°
Secondaries: 126°
In: 81°

R the transfers staggered from factory?

 

[Deets066]

This one has higher timing numbers than any I've done yet.

Ex: 95.5°
Mains: 123°
Secondaries: 126°
In: 81°

Damn, high ex!

Seems to hold very well in the cut. Suprized me, I would've guessed 99

 

[Poleman]

Good job Randy!!!! Looks like it really pulls and keeps it's rpm's well!!

 

[Mastermind]

R the transfers staggered from factory?

Sloped......not staggered.

Damn, high ex!

Seems to hold very well in the cut. Suprized me, I would've guessed 99

Stroker motors can use more exhaust.

 

[Mastermind]

Good job Randy!!!! Looks like it really pulls and keeps it's rpm's well!!

I'm using a AM 272 coil on one right now. I made a longer wire from a roll of Stihl lead. Seems to be easier.