Not So Pro 3

[Slumberjack]

Alan in Missouri I here does a good job
Can’t remember his ope name [emoji35]
I gettin old and can’t remember chit [emoji3061]

Maybe someone else knows


Sent from Hoskey hilltop

I’d like to see one rev. Not sure if their bearings can handle the rpm. Also I believe most had pressed in wrist pins. That may cause an issue with 10k+ rpm. Not sure though....

 

[dall]

Alan in Missouri I here does a good job
Can’t remember his ope name [emoji35]
I gettin old and can’t remember chit [emoji3061]

Maybe someone else knows


Sent from Hoskey hilltop

awol

 

[redline4]

Where is your snow Ed? We got about 6" total Friday into Saturday. 2 rounds of blowing and shoveling to stay ahead of the crap freezing to the driveway and sidewalk.

It all stayed south of me. I think Wautoma was about as far north as the snow got.
I heard you guys got hit down there.

 

[p61 western]

Good evening mfers.

 

[redline4]

Good evening mfers.

Whats happening out west Mike?

 

[hoskvarna]

awol

Bingo Dallas thanks


Sent from Hoskey hilltop

 

[p61 western]

Whats happening out west Mike?

Getting some rain and wind. Sup with you Ed?

 

[redline4]

Getting some rain and wind. Sup with you Ed?

Above average temps and no snow. Little wind lately too. It does make it easier to get stuff done out in the woods without the white crap on the ground, so no complaints about that.

 

[p61 western]

Above average temps and no snow. Little wind lately too. It does make it easier to get stuff done out in the woods without the white crap on the ground, so no complaints about that.

Basically the same thing here. Feels like spring in December lol.

 

[dall]

damn slackers

 

[Mastermind]

damn slackers

Factual Statement

 

[dall]

Factual Statement

especially you gramps

 

[Mastermind]

especially you gramps

If I had feelings dot dot dot

 

[dall]

If I had feelings dot dot dot

lol like they say at work leave those in the parking lot lol

 

[huskihl]

Those old things had a lot more torque than saws today in their cc class right?

It’s not that they had lots of torque, they just didn’t have much hp. So all you felt was torque. That’s what Joe’s dyno says anyway

 

[Egg Shooter]

It’s not that they had lots of torque, they just didn’t have much hp. So all you felt was torque. That’s what Joe’s dyno says anyway

Makes sense to me.

 

[Egg Shooter]

Y'all have a good night. I'm out.

 

[dall]

Y'all have a good night. I'm out.

night slacker

 

[Egg Shooter]

night slacker

Night.

 

[Dream]

I’d like to see one rev. Not sure if their bearings can handle the rpm. Also I believe most had pressed in wrist pins. That may cause an issue with 10k+ rpm. Not sure though....

Weak spot on a 10 series Mac is tue wrist pin bearings. They put them in the piston instead of the rod. If they go, they "needle" the cylinder. Almost always a total loss of piston and cylinder. Good bearings, just not sure what kinda Revs they can handle.