Not So Pro 3

[dall]

I don't think I belong here. Didn't slack any the last two hours!

View attachment 301855

it belongs here lol

Who's a happy mfer needs a snickers?

lol 2 at a time for me

 

[Lightning Performance]

it belongs here lol

lol 2 at a time for me

Double slacker

 

[dall]

Double slacker

lol just dont like some people at times

 

[Steve]

Anti slacker. How dare you

I know, go stand with Randy...

 

[Steve]

Sumbody cut yer trakter in half…

Still looking for that sum bish too.

 

[Egg Shooter]

What is this Kandy with the K?

You know when two people are together, say Ben and Jennifer would be Bennifer? Well Kandy is ma name for a "couple" of.....holes up in here. Not here here but ope.

 

[Lightning Performance]

I know, go stand with Randy...

Lol

 

[Mastermind]

Right. I haven't done that lol

Nor have I.

lol how old was the old one

Well the truck is like 38 years old.....so.

 

[dall]

Nor have I.



Well the truck is like 38 years old.....so.

lol probably the trucks 4th motor lol

 

[hoskvarna]

Evening boys
Was out mowing more multi flower and small locust trees and it quit mowing so thought I’d sheered the bolt. Took cover off sheer bolt ok
Went home to shop and it seems like the gearbox is locked up [emoji2959][emoji2959][emoji2959][emoji2959][emoji2959][emoji2959][emoji2959]
Oil level ok so a bearing must have took a chit. I guess I will be taking it off and rebuilding it [emoji35]


Sent from Hoskey hilltop

 

[Lightning Performance]

Well the truck is like 38 years old.....so.

And... you didn't even try to put a seal in it, lmao. Ye of too much faith

If you cleaned and painted it that will fuggit up every time ​

 

[Dream]

Well.....no. I was trying to save a few bucks. I'll go stand in the corner now.

Aint even liking that. Starter AND water pump.
You know better.
And then put a stupid POS Chubby alternator on it.
Ford put the regulator over on the fender where it would stay cool for a fugging reason Randy.
Get burned, get learned.

 

[Dream]

Yeah, but only a very special few have tried to build an engine on a tight budget and re-used a water pump that subsequently blew apart in a flash dyno cell and cost $100 an hr to mop up and change as well as being charged out at retail.....

Again.
Education.
Worth every penny.
Learned that more than once.

 

[Dream]

I don't think I belong here. Didn't slack any the last two hours!

View attachment 301855

Well that sucks. You have a Ferd in the middle of your Zetor. It'll NEVER run right again.

 

[Dream]

Nor have I.



Well the truck is like 38 years old.....so.

Oh fer fuggs sake...
Really?
Last time I had a motor out, I wasnt thinking about how much money I could save.
I was thinking about how much I DIDNT want to crawl my fat stupid arse under there later and replace that, instead of while it was taken apart and RIGHT FUGGING THERE and easy to get to.
I mean, I keep a tally of how many times I have to bend over or get on the ground these days.
Fella reaches a certain level of fatness that requires outside assistance when these things occur.
Mobile cranes are EXPENSIVE.

 

[Dream]

Evening boys
Was out mowing more multi flower and small locust trees and it quit mowing so thought I’d sheered the bolt. Took cover off sheer bolt ok
Went home to shop and it seems like the gearbox is locked up [emoji2959][emoji2959][emoji2959][emoji2959][emoji2959][emoji2959][emoji2959]
Oil level ok so a bearing must have took a chit. I guess I will be taking it off and rebuilding it [emoji35]


Sent from Hoskey hilltop

Liked for sympathy Mark. That sux.

 

[Dream]

lol probably the trucks 4th motor lol

Its not a chebby slacker.
Ferd drivetrains are made specific to the vehicle.
Not made to swap out as each goes bad every week or so.

 

[Kiwioilboiler]

I don't think I belong here. Didn't slack any the last two hours!

View attachment 301855

Yeah but did you find a fixable problem?

 

[Kiwioilboiler]

Again.
Education.
Worth every penny.
Learned that more than once.

I really wasn't in a position to be doing such a project Brent. Had not long started my first job out of uni with Firestone on the princely sum of $13/hr.
My Improve Everything sickness kicked in and I started building a 4.1 alloy head 6 for my Fairmont Ghia. Motors a relative of @Steve s 300 and the mighty Barra. Machining long block and porting the head sucked up all my cash, and traveling over 300 miles every spare weekend to work on it kept it that way.
Turned out good, but a Cleveland woulda turned more heads than a warm 6 did.
Sold it a couple of years later to buy an 89 RS Legacy. Never looked back. AWD Turbo, yes that covers ground rapidly thank you.

 

[Agent Smith]

Everyone needs a hobby...

https://www.facebook.com/video.php?v=2938168433109422