Armbru84
Just trying to get by
- Local time
- 11:13 PM
- User ID
- 1549
- Joined
- Jul 14, 2016
- Messages
- 1,854
- Reaction score
- 10,913
- Location
- Michigan
Selling my nice ported 084. This saw has a lot of history as it started as @trooney saw and he got screwed on an eBay deal. Thread here:
https://opeforum.com/threads/sometimes-people-absolutely-suck.4815/
I bought the saw from him and Stratton redid it based on a few parts being sent to him. I believe Dave sent the piston. I have had it apart and everything looked good to me...I spun the base on my lathe to check it and I didn’t see anything that warranted me doing any work to it. I have out at least 5 gallons of fuel through it. Probably 10. Always fires up and pulls a long bar very well.
I put a new handle on it 2 years back and also upgraded the cosmetics. There are a few cracks on the top cover as shown. It stays on fine...just wanted to be up front on that. I was running a max flow but have the covers as shown as well. I recently put a new buffer by the carb...it’s the 088 style. Dogs are custom 10 gauge stainless that Dave sells. They are both sharp and stout.
lots of guys on where have ran the saw. Woodpecker bore cut a maple with the 50” setup on it if I remember correctly. Below is a recent vid while at Kevs. I can also do vids if needed. I do potentially have 50 and 36 inch cannon bars that could go with this.
$1,300 and the ride. PayPal F&F or add the 3%.
https://opeforum.com/threads/sometimes-people-absolutely-suck.4815/
I bought the saw from him and Stratton redid it based on a few parts being sent to him. I believe Dave sent the piston. I have had it apart and everything looked good to me...I spun the base on my lathe to check it and I didn’t see anything that warranted me doing any work to it. I have out at least 5 gallons of fuel through it. Probably 10. Always fires up and pulls a long bar very well.
I put a new handle on it 2 years back and also upgraded the cosmetics. There are a few cracks on the top cover as shown. It stays on fine...just wanted to be up front on that. I was running a max flow but have the covers as shown as well. I recently put a new buffer by the carb...it’s the 088 style. Dogs are custom 10 gauge stainless that Dave sells. They are both sharp and stout.
lots of guys on where have ran the saw. Woodpecker bore cut a maple with the 50” setup on it if I remember correctly. Below is a recent vid while at Kevs. I can also do vids if needed. I do potentially have 50 and 36 inch cannon bars that could go with this.
$1,300 and the ride. PayPal F&F or add the 3%.