MS880 with MS361 coil

[Brewz]

No, will be tackling it tomorrow afternoon.

 

[Brewz]

Just took it back to half a key advance and it starts good now.
Going to let it go cold and will try again

 

[hseII]

Some news Here?

Runs good, but the oiler oils too good...

 

[Brewz]

Semi chisel 404 work chain and a 7 tooth sprocket
Timber is dead and stupid hard.
Tuned to 13400 rpm

 

[smokey7]

Wow she woke right up and sounds really good .

 

[hseII]

Semi chisel 404 work chain and a 7 tooth sprocket
Timber is dead and stupid hard.
Tuned to 13400 rpm

Nice!!!

 

[hseII]

Here's Mine:

 

[Brewz]

I think it's still a bit too far advanced as it pops a bit but it runs good.
A little bit extra advance shouldn't hurt it

 

[Termitebuffet]

Here's Mine:

Looks heavy.....[emoji106]

 

[hseII]

Looks heavy.....[emoji106]

Real Good Tailgate Cables.

 

[Brewz]

 

[hseII]

View attachment 72838

Brewz,

What rpms are you seeing?

 

[Brewz]

13400 ish.
Thats what its pulling in the begining of the video.
The saw was at full temp too.
I had run it for several cuts for the first time and when I tached it out of the cut it pulled high 14700.
I put it down and went for a screw driver haha

 

[Brewz]

These were first cuts.
Chain is sharp but the timber is indescribably hard and its a forked gnarly section.
Im talking 15000+ Jenka hardness. Its up there with dry ironbark.