MS362 Crankshaft

[ctylerc1995]

I picked up an almost new MS362CM that was thought to have a scored P/C, come to find out the P/C&rings look new, the crankshaft bearings are all shot.
I'm guessing that to replace the lower rod bearing, the whole crankshaft is needed.
Does anyone have a source for one?

1140 030 0400 is the part number I'm coming up with.

 

[Adirondackstihl]

Are you sure the rod bearing is shot and it's not just the crank bearings?

 

[fordf150]

new crank isnt bad priced. last one i bought was $169 IIRC.

 

[fordf150]

11400300404 $163

 

[ctylerc1995]

Are you sure the rod bearing is shot and it's not just the crank bearings?

Yes, the rod bearing looks shattered and chunks of it fell out.

11400300404 $163

Thank you!
A lot cheaper than I would have though, I was guessing around $250!

 

[dall]

i think i have a good one out in my building ill look tomorrow to make sure

 

[fordf150]

A lot cheaper than I would have though, I was guessing around $250!

I think they had enough of them failing they made em cheap to buy. I have replaced quite a few. total parts bill still adds up to quite a bit once you replace bearings and gasket set

 

[ctylerc1995]

Got a quote from my "friendly stealer" today, $229!
@dall you didn't happen to come up with one did ya?

 

[dall]

yes i have one out of saw but threads will need chased some dummy before me must of hit it with hammer and messed up thread but i do have another in a saw ill show pics in a few when they get to my email on here dont buy one yet

 

[dall]

 

[dall]

here you can see the damage on thread i think fixable other crank is still in saw

 

[ctylerc1995]

View attachment 12401

here you can see the damage on thread i think fixable other crank is still in saw

How much you want for it ? Do you use PayPal?

 

[Adirondackstihl]

View attachment 12401

here you can see the damage on thread i think fixable other crank is still in saw

2 minute fix with a thread file

 

[dall]

i just wanted to show how bad they was and to me it isnt to bad but wanted to be open about and not try to hide the damage the crank is nice and free and no slop i think i had pic of the big bearing area not discolored and clean but will need dust knocked off it

 

[wujekt]

How much do you ask for it?