Looking for 3/8”LP 7pin small spline rim sprocket

[KYsawman]

Does it still have that plastic clamp in the intake?

Yes it still does, and it is not leaking, I believe keeping the saw clean and a sharp chain has kept the heat down. I think heat is the main reason that the plastic clamp failed. I have a OEM metal clamp, 350 bearing cup, and 346xp NE cylinder ready when the time comes, but till then I’m just going to let her eat.

 

[Duane(Pa)]

Great stuff! In the right hands, these tools can/will last a long time.​

 

[Dub11]

Yes it still does, and it is not leaking, I believe keeping the saw clean and a sharp chain has kept the heat down. I think heat is the main reason that the plastic clamp failed. I have a OEM metal clamp, 350 bearing cup, and 346xp NE cylinder ready when the time comes, but till then I’m just going to let her eat.

Never a more true statement right there.

Did you see that guy that had a build thread for these saws and was using a crank stuffer off a string trimmer and with a little filing you could have stuffers on these saws?

 

[KYsawman]

Never a more true statement right there.

Did you see that guy that had a build thread for these saws and was using a crank stuffer off a string trimmer and with a little filing you could have stuffers on these saws?

No I missed that one, it would be nice to try stuffers on these saws,

 

[Mycamaro_68]

I have one left but can make more.

What's up Mike, how ya been?

 

[Dub11]

No I missed that one, it would be nice to try stuffers on these saws,

http://opeforum.com/threads/husqvarna-353-build.13286/

I'm gonna try this on a 350 with the 44mm OP head for *s-words and giggles. I'd like to see how far behind my 2153 it would be.

 

[ajschainsaws]

Hey Sondre did you get sorted with a small spline 3/8LP rim I got the
Standard spline sprockets and there smooth running

 

[SOS Ridgerider]

Hey Sondre did you get sorted with a small spline 3/8LP rim I got the
Standard spline sprockets and there smooth running

Hi Andrew. Yes, I got it sorted out. Another member here @Johnmn had a Stihl rim that was modified to fit small spline. Works great now.
I think I have a standard spline rim for 3/8LP somewhere as well. Not sure where it came from. Lol

 

[Wilhelm]

Hey Sondre did you get sorted with a small spline 3/8LP rim I got the
Standard spline sprockets and there smooth running

I'll have to keep You in mind if I ever get to successfully adapt the PowerSharp system to run on my D009 saws!