Jonsered 2077 Build

[Huskyslinger]

So I started working on another project. building a west coast 2077. Squish was .059" so it went to the lathe for a trim job. Brought squish down to .025"

 

[Huskyslinger]

Few more pics to look at

 

[Huskyslinger]

Here is where the numbers ending up at. I have already roughed in the Exhaust to 100* thinking of taking transfers to 122*-123*? input is more than welcome. More pics to come!

 

[Huskyslinger]

Few pics of ports being roughed in.

 

[Huskyslinger]

Project got put on hold for a bit as this little gem followed me home!

 

[Huskyslinger]

Transfers roughed in

 

[mdavlee]

Nice port work. I’d say 122-123 would be a good spot to start.

 

[Huskyslinger]

Best little trick out there! Thanks to those senior porters!

 

[Huskyslinger]

Something about the self satisfaction making something look this cool! Even if it dont do much, it still looks freaking awsome!

 

[Huskyslinger]

So I am wondering what I should take the intake to? Since I am new to this and with the reading I have read. I am thinking that I should leave it alone? or should I got to 78* or 79*? Thoughts?

 

[Huskyslinger]

So the numbers are at 100* 122* 77*

 

[mdavlee]

I wouldn’t mess with it for 1 degree. Maybe 3 to get to 80. I’d run it as is and see if it feels lacking somehow.

 

[Huskyslinger]

Now that you say that and i read it, you're right no point for that small amount.

 

[Huskyslinger]

Still working on muffler. Out of four this was the only one like this. Im thinking its off the 2083? Anyway the other three are all one piece.

 

[Huskyslinger]

Did a little more work on muffler. You can see the difference between the stock and mine.

 

[Huskyslinger]

So here is the finished cylinder. Go ahead and critique!

 

[Huskyslinger]

 

[Huskyslinger]

Here is a little of the assembly. This saw has been apart for at least 2 years! makes it fun to assemble!

 

[Huskyslinger]

 

[Huskyslinger]