Husqvarna crankcase splitter

[Mark71gtx]

Looking for usable dimensions to make a homemade crankcase splitter. I looked at one elsewhere and the measurements did not jive... Thanks!

 

[Milkman31]

I made mine from a cardboard cutout that was gave to me. Send me your address and I'll send one your way.

 

[Tor R]

I took picture of oem splitter, If you wait until tomorrow i can post a picture, picture scale is A4 format

 

[beaglebriar]

I found a PDF over on AS. I think the user name was deprime?? Print it out a little big like 6 3/8" outside. This will give you the proper inside dimension when you cut out the final pieces which is the important part. Cut out the paper trace it on some thin steel with a sharpie. Carefully cut it out with a plasma torch. Then clean it up with a die grinder. Use this as a template to cut your actual jaws. They will come out nicer this way. Using 6" flat stock will make it easier to keep everything square. I used 3/16" and it's plenty strong.

 

[Glock37]

pm sent

 

[beaglebriar]

View attachment 4100 View attachment 4100 View attachment 4099

Crude but effective!

 

[Glock37]

I made these. Powdered

Pm if interested.


Sent from my iPhone using Tapatalk

 

[Mark71gtx]

View attachment 4100 View attachment 4100 View attachment 4099

Now that is being resourceful! I dig it. I now have an idea for saws the splitter will not fit. .

 

[Glock37]

Remember heat is your friend separating cases


Sent from my iPhone using Tapatalk

 

[Cat Face-Timber]

PM SENT

 

[Tor R]

This is the drawing from one Husky OEM cranksplitter (A4 papir):

 

[stihl_head1982]

Remember heat is your friend separating cases


Sent from my iPhone using Tapatalk

Yep, heat is good. Even muh dog is in heat.

 

[panteliss]

the distance between the jaws must be 28mm for the big saws splitters example 372, 395
the distance between the jaws must be 24mm for the small saws splitters example 242, 346 ...
for the other dimensions no matter so much if you are out a little

 

[panteliss]

I made these. Powdered

Pm if interested.


Sent from my iPhone using Tapatalk

Nice work here

 

[Glock37]

Now that is being resourceful! I dig it. I now have an idea for saws the splitter will not fit. .

We split a 024 and a ms 880 with this one

Thats a pretty big range


Sent from my iPad using Tapatalk

 

[PA Dan]

We split a 024 and a ms 880 with this one

Thats a pretty big range


Sent from my iPad using Tapatalk

Yes we did!

 

[drf256]

Hers mine, made by Brian Sty57 and stuck together by me.




Sent from my iPad using Tapatalk

 

[stihl_head1982]

Nice work here

Yes, I like the colors as well. How much is the powdered finish?

 

[David Young]

Also from sty57

 

[paragonbuilder]

Crude but effective!

Where did that original post by motor head go?
I don't see any pics?


Sent from my iPhone using Tapatalk