holy hell!

[rattler]

Jug if you can't find them I might scrounge something up.

 

[TJ the Chainsaw Mechanic]

it happened last night DURRRR

Must have cause everything looked fine to me! LOL!

 

[MG2186]

really?near carnage pictures.
View attachment 16288
View attachment 16290
oh Base gasket where are you?
View attachment 16291
missing piece of gasket was replaced by wood chips.
View attachment 16292
guess what was tightened up crossways in the exhaust flow.lol
this 288 ran great.just used it a few times to buck and noodle some big rounds of wood.i did notice the carb tuned funny and the idle was probably 3500 rpm until it warmed up.its a wonder it would even have enough impulse to run.
@Definitive Dave do you have husky 288 gasket sets? with intake gaskets?no base or case gasket needed.i swear ill use some sealer this time. i really don't think the guy i bought the saw from done this.

You should of said something when I sent the cylinder I would of sent s couple gaskets with


Sent from my iPhone using Tapatalk

 

[Jughead]

Daves getting me a set and some rings out too along with some bearings.appreciate it fellers.
@MG2186 just found out the day after i got the cylinder.