High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

echo cs-501p stalling

eonk

Active OPE Member
Local time
7:39 AM
User ID
32592
Joined
Apr 19, 2025
Messages
6
Reaction score
8
Location
Wadsworth, Ohio
Country flag
I recently purchased the cs-501p and used it once. It ran fine. About a month later it will start fine and cut, but when i release the trigger, it dies. it has fresh gas. Any thoughts on the problem? I cant take it back to the dealer, but if I am making a silly mistake, I would like to know. By the way this isn't my first chainsaw.
 

huskihl

Muh fingers look really big
GoldMember
Local time
7:39 AM
User ID
360
Joined
Dec 31, 2015
Messages
23,117
Reaction score
147,672
Location
East Jordan, MI
Country flag
I recently purchased the cs-501p and used it once. It ran fine. About a month later it will start fine and cut, but when i release the trigger, it dies. it has fresh gas. Any thoughts on the problem? I cant take it back to the dealer, but if I am making a silly mistake, I would like to know. By the way this isn't my first chainsaw.
Is it new or did you buy it used?
 

EFSM

Super OPE Member
Local time
6:39 AM
User ID
29079
Joined
Apr 30, 2024
Messages
527
Reaction score
1,191
Location
Extreme southern IL
Country flag
Echo tends to set the idle speed fairly low from the factory on those saws. Try turning the idle screw up half a turn. It is located right by the starter handle on the shroud below the air filter cover.
 

Ed Sybert

Active OPE Member
Local time
7:39 AM
User ID
31221
Joined
Jan 28, 2025
Messages
19
Reaction score
22
Location
Hanover, PA
Country flag
I had the same issue with a new CS4910. I simply adjusted the idle speed faster by turning the screw about a half-turn clockwise. The OP may need more or less to reach a stable idle speed. Just be sure to keep it below the speed at which the chain begins to turn.
 
Top