SELLING Cherry Dolmar 5105

[Woodbutcher56]

No retuning necessary. It certainly didn’t affect mine.

You forgot to mention the saw would dump gas from that vent after trimming the duck bill!!

 

[Ronaldo]

Mine hasn’t leaked much and not every time I fuel. I stop short of filling it clear up to the neck and that helps.

 

[Woodbutcher56]

Mine leaks a fair amount every time I refuel. Open and close the fuel cap.

 

[Ronaldo]

Mine leaks a fair amount every time I refuel. Open and close the fuel cap.

Perhaps you nipped off more material than I did. I’ve done two saws and neither one leaks much. A little spot of fuel on the tailgate is all I’ve ever had. I was instructed to just nip off a bit of a corner on the duckbill. It didn’t seem like it was enough when I did it but it worked!!

 

[Woodbutcher56]

You may well be correct. I just ordered a new tank vent from Chainsawr . I ordered 2 I'll try again to nip just a tiny amount and keep one in tact. Is the vent designed to relieve pressure in the tank or to allow air in to prevent a vapor lock?

 

[Ronaldo]

Allows air in.

 

[Woodbutcher56]

I thought that would be the case