- Local time
- 4:40 AM
- User ID
- 573
- Joined
- Jan 17, 2016
- Messages
- 2,675
- Reaction score
- 14,397
- Location
- cape cod ma.
I like big pistons, Nice build.
Baseline cuts, or is it already dickered with Steve?
First cut, rich and chain issue with a gnarly knot it did not like.
Baseline cuts, or is it already dickered with Steve?
Does the carb have a governor by chance? Limited coil possibly ?It's bone stock yet and I may have to re do this after some adjustments. The carburetor screws would not budge and it was only spinning up to about 11,800rpm. Chain wasn't grabbing and a big knot by the bucking spikes didn't like being cut much at all. It was still better than the triple shark fin safety chain that came with it. It's like a mulching blade on a lawn mower. Lol
I believe the coil is limited to 13 800 but I am likely wrong...Does the carb have a governor by chance? Limited coil possibly ?
Does the carb have a governor by chance? Limited coil possibly ?
It's bone stock yet and I may have to re do this after some adjustments. The carburetor screws would not budge and it was only spinning up to about 11,800rpm. Chain wasn't grabbing and a big knot by the bucking spikes didn't like being cut much at all. It was still better than the triple shark fin safety chain that came with it. It's like a mulching blade on a lawn mower. Lol
I'm learning about these saws through you Steve. Thank for taking the time and sharing.All stuffs I have to figure out.
Double D on the H screw
Double D on the H screw
Nah all ya have to do is put the blade on right side up. Bam! All your problems solved.
I'm learning about these saws through you Steve. Thank for taking the time and sharing.
Not here either lol.I have one, I'll give it a try.
You said"blade" lol
I'm trying, this isn't Makita country here.
You said"blade" lol
What’s the status of captain blueberry