395 xp tools

[Socalmisfit]

I’m gonna be putting cases on my 395 soon and can’t find the part numbers for the crankshaft assembly set. The tool that pulls the crank back through the cases. If anyone knows the part number I would appreciate it. Also the seal install tool. Thanks guys.

 

[srcarr52]

I don't think there is one kit that has all you need to pull in a crank for the 395.

The 288/394/2100 kit has the correct bushing and PTO side shaft but the flywheel side shaft is the larger 10mm thread needed for a 394. Use a socket over the bushing to drive the flywheel side seal in the correct distance, use the wider side of the bushing for the PTO. The art number 502 50 30-08.

The 372 kit has the needed flywheel side shaft (8mm) but the rest of the kit is for the inboard clutch of the 372. The part number 502 50 30-15.

The seal protector sleeve is 502 50 52-01 and works for both sides.

 

[Socalmisfit]

I appreciate the reply I have the 372 tool I guess I would only need the other kit to get it done. Then swap the sleeves around?

 

[srcarr52]

I appreciate the reply I have the 372 tool I guess I would only need the other kit to get it done. Then swap the sleeves around?

Yes, the OD threads are the same on the shafts.

The seal protector is a must, or else you spend 5 minutes walking the seal in a little at a time while having to push the lip back with a pick.

 

[Squareground3691]

Might help ya out real good deal to . Husqvarna Fitting Tool Part # 502503008 https://a.co/d/iZvt45r