359 porting recipe

[MG2186]

Anybody got a good porting recipe for a 359 they would care to share and help me out?


Sent from my iPhone using Tapatalk

 

[Milkman31]

I think most like to put the 357 jug on the 359 then port!

 

[Ironworker]

I did one that Randy cut the base and squish, it's a torque monster.
Ex. 103
Transfers 120
And I just widened the intake, maybe lowered it a touch if that.

 

[Mastermind]

Good recipe there Numa.

 

[Ironworker]

I got it from you.

 

[Danders]

I did one that Randy cut the base and squish, it's a torque monster.
Ex. 103
Transfers 120
And I just widened the intake, maybe lowered it a touch if that.

I'd really like to know where your intake ended up at. Cutting the base would have increased the intake timing - would you remember how much was taken off? It looks like the intake has more duration than the exhaust stock and I'm curious if yours ended up that way.

 

[MG2186]

I had to put epoxy in mine to get it right. It runs well


Sent from my iPhone using Tapatalk

 

[Ironworker]

I'd really like to know where your intake ended up at. Cutting the base would have increased the intake timing - would you remember how much was taken off? It looks like the intake has more duration than the exhaust stock and I'm curious if yours ended up that way.

Can't really tell you, but it is one of my better saws, especially torque wise.