2095 with an issue.

[Sleeper]

Looking at a used 2095 for about 500 bucks. Seller says saw runs, but won't idle. Crank seals? Carb adjustment? Carb kit?

Have about 1 hour left on it.

 

[jacob j.]

Could be all of the above. It could also have the tank vent blocked off.

 

[Sleeper]

Could be all of the above. It could also have the tank vent blocked off.

Too risky to buy for that much? Are seals and stuff still around or is it not shared with 394/395?

 

[decableguy2000]

part number for the seals says yes same as 394, 395, 288 part # 503 26 02-05

 

[Warped5]

.... and some parts can be a problem to get.

 

[bryanr2]

Looking at a used 2095 for about 500 bucks. Seller says saw runs, but won't idle. Crank seals? Carb adjustment? Carb kit?

Have about 1 hour left on it.

There are some Nla parts on that saw, and from what I remember on the one I had to rebuild, parts were kinda pricy.

 

[Sleeper]

Probably be better off getting a 2188, then?

 

[Chainsaw Jim]

You can get a 394 in the same condition for less than that.

 

[Sleeper]

I'm going to pass on it. Probably get a 394 at some point. Just looking at getting some Jonsereds in the stable before they become snapped up and expensive. Found some locally, which I prefer anyhow. Face to face deals. They're not as big of saws, but still good saws.

There is a 820, but I know parts are a PITA to find for those...

 

[hseII]

Probably be better off getting a 2188, then?

395, but yes.


that's only after you share the seller's info & get him to come off the price a bit.