FOUND IT 18-20” bar for MS462

[Thumper88]

I’m looking for a 18-20” bar and chain combo for an MS462. Will also look at just the with no chain. Oregon, Stihl or other brands are fine. Need to use my 462 for chunking out a big bastard in a few weeks and don’t wanna haul it up the tree with the current 28” that’s on it. Would prefer full chisel chain, but not a deal breaker. Must be 3/8 though. Will need to be shipped to Oliver Springs Tennessee 37840

 

[PA Plumber]

These were on sale and I believe a good value.

https://www.harvesterbars.com/collections/gb-chainsaw

 

[Lightning Performance]

These were on sale and I believe a good value.

https://www.harvesterbars.com/collections/gb-chainsaw

Nice deal imo.
You think the 18" would be good to cut down?
Stihl bars are a pia to cut down!
I won't waste my time on a cheap Oregon bar.

 

[showrguy]

These were on sale and I believe a good value.

https://www.harvesterbars.com/collections/gb-chainsaw

Thanks for posting that.... I just ordered 3 of em..

 

[PA Plumber]

Thanks for posting that.... I just ordered 3 of em..

You're welcome. Got it from a thread someone started about this a few weeks ago.
I picked up two 18 inchers. Seems like shipping took a couple of weeks.

 

[PA Plumber]

https://www.harvesterbars.com/collections/gb-chainsaw
Not sure what you mean by "cut down."
My older GB bars are tough. Have a 24 incher that has been through a bunch of chains over the years.
True up the rails, debur, and pinch the groove for clean sailing. It's been a good bar.

 

[woodfarmer]

I have a new rollomatic e for $40 and a very slightly used es for $60, 20”

 

[Orangeinthebarn]

Pm sent

 

[chipper1]

Nice deal imo.
You think the 18" would be good to cut down?
Stihl bars are a pia to cut down!
I won't waste my time on a cheap Oregon bar.

They're great bars, but very hard, I would think they are just as hard as a stihl.
I beat the heck out of my "junk" bars .

 

[Lightning Performance]

They're great bars, but very hard, I would think they are just as hard as a stihl.
I beat the heck out of my "junk" bars .

Maybe a big grinder will be faster next time than a cutoff wheel.
Have to cut on a Sabre just a bit. Filed the slot on my Cannon. Took an hour to open it up. Ruined three files, one round two flat. Bigger was better. Dreading cutting of a 24" ES.

 

[Lightning Performance]

I’m looking for a 18-20” bar and chain combo for an MS462. Will also look at just the with no chain. Oregon, Stihl or other brands are fine. Need to use my 462 for chunking out a big bastard in a few weeks and don’t wanna haul it up the tree with the current 28” that’s on it. Would prefer full chisel chain, but not a deal breaker. Must be 3/8 though. Will need to be shipped to Oliver Springs Tennessee 37840

Just take the 660 with a 28", fun times

 

[Orangeinthebarn]

Met with Jordan today, thumper88. He was great to deal with. Great communication and on time. Don’t hesitate to deal with him. Honest man

 

[Thumper88]

Met with Jordan today, thumper88. He was great to deal with. Great communication and on time. Don’t hesitate to deal with him. Honest man

Thanks buddy. I can say the same for you. On time, bar and chain were exactly as described and very fairly priced. Hope we can do business again sometime