166

[Cut4fun]

166 after rebuild. running fat fat fat for test cuts at the rpm this Marcel Vincent ported 166 runs at.
running 11T

 

[Cut4fun]

Put on muffler later for test. Slowed down to turd pace LOL pulling 11T

 

[Adirondackstihl]

Did you say 166?

 

[Cut4fun]

I couldnt sell the 3 I had fast enough. Can you say overrated.

Not going to sugar coat this just for the collectors feelings.

Worst feeling saw in my hands I ever had. Felt like a half filled water balloon.

 

[Cut4fun]

Stock and woods ported they are

 

[Adirondackstihl]

I know someone looking for (2) more to round out his collection.

 

[Cut4fun]

After I unloaded everything I quit looking for parts etc to stash back.

There was 2 FS here down the road about 20mins.

Friend bought them and flipped one on FEEbay to pay for the other one. Free 166 that way for him.

 

[Cut4fun]

Difference in woods port and race port 166 exhaust port

The woods port had 190psi and just a tad much for my liking in a work saw. All my works saws were normally around 180psi. Just not a fan of high psi in a work saw and wont buy any with goobs of psi.

 

[Adirondackstihl]

I've seen pics of that bottom cylinder before.
There's more pics hiding somewhere isn't there?

 

[Cut4fun]

I've seen pics of that bottom cylinder before.
There's more pics hiding somewhere isn't there?

Lost a bunch when racesaws site was taken down by past admin. = a-hole

Still have a few.

The bottom one was the one I had to split the metal tanks on. The alky/nitro was getting bar oil in it.

 

[Cut4fun]

Nothing like Lee's 100 166 idling at the same time. But I did like the sound at idle they made.

 

[skippy]

166 after rebuild. running fat fat fat for test cuts at the rpm this Marcel Vincent ported 166 runs at.
running 11T

That saw rips !

 

[bryanr2]

yep. pretty sick.

 

[Cut4fun]

split the metal oil and fuel tank to seal with 1194. still holding alky/nitro separated from bar oil today.

 

[skippy]

split the metal oil and fuel tank to seal with 1194. still holding alky/nitro separated from bar oil today.

Cut4fun can you keep us posted on this please

 

[Cut4fun]

Cut4fun can you keep us posted on this please

Already done it if you look at case close. Long ago and still holding for new owner too.

 

[skippy]

Already done it if you look at case close. Long ago and still holding for new owner too.

My bad