Wilhelm's latest activity
-
Wilhelm replied to the thread The dogs of OPEforum.Freshly bathed, she was still a bit wet - my little wooly mammoth. -
-
I have an Oregon 511a and a 511ax. I don’t use the a model very often, because the ax vise is waaaay better. They’re both pretty stout...
-
I have a Tecomec Super Jolly, and a Tecomec Jolly Star. Both are setup with an air nozzle to help with overheating cutters. I got...
-
🦫 🦷
-
Wilhelm replied to the thread The Metalworking Thread.19mm Allen wrench CR-V, snapped w/o prior deformation. Very fine structure, nearly clean break. 24mm 12.9 grade bolt, shoved minor...
-
-
Wilhelm replied to the thread The Metalworking Thread.I worked a 19mm CR-V allen wrench piece today. Milling the end flat with a Solid-Carbide 10mm end mill, and drilling the hole with a...
-
-
These are what I got. They worked beautifully drilling holes through 1/4in plate yesterday...
-
Brussel sprouts and honey should also help with your gas supply...
-
There is a caboose on display in a park near one of the county offices that my job serves, it is unusual on two counts. The build date...
-
Getting it past the wife would require some careful planning...
-
Check this out. On Monday, an ex-C&O caboose wearing original colors was being used on a revenue train in Lexington, KY. Even though the...
-
Philbert
-
-
-
New bars in the 2388. Beans aren’t very good up here this year. See small beans. Northern lights Peice of soybean stubble stuck...
