Philbert's latest activity
-
PYep, u can build an entire birch canoe with just a crooked knife l, an axe and some wooden wedges. Besides cutting on my stands of...
-
PBIg Old buzz saw blades get work hardened ( not to mention excessive heat which also hardens the steel, if run dull) at this point they...
-
PBand mill blades are about .063 thick, then it depends on the particular type , hard edge flex back, hard edge hard back ( spring steel...
-
PAnyone have any use for either of these throw away saws. Both run and oil fine. Guy I got them from tried working on them lost the air...
-
PPhilbert replied to the thread Crooked Knife?.Ooooh! Really large bandsaw blade (like those used on mills) might be a good option! I am sure that there are better alloys to use...
-
PI have a few buzz/cordwood saw blades (20" to 30" diameter) that are cracked.. I am thinking about grinding/scoring a line and see how...
-
PPhilbert replied to the thread Crooked Knife?.Thanks. That’s very helpful. I was thinking about converting old kitchen knives from garage sales. Re-shaping the blades and handles...
-
PI make knives out of old circular saws every so often . The metal is a high chromium content. you can cut it and file it easily...
-
PYou obviously have more patience than I do. :thumbsup:
-
PPhilbert replied to the thread Tell me a joke......Not really ’a joke’; more inspirational. Philbert
-
-
PDrywall is all hung, crew will be coming back to tape and finish. Carpenter has been working on getting the exterior work done...
-
PI've set the rackers on that .325" loop Before After I have set up my grinder to do rackers for those coworkers 7 loops. This was...
