lehman live edge slab's latest activity
-
lehman live edge slab replied to the thread MCCULLOCH The official McCulloch thread.Planned on rebuilding the carb, has an hl Tilly on it and I have all the kit parts in my drawers. Was going to pull flywheel and clean... -
lehman live edge slab replied to the thread MCCULLOCH The official McCulloch thread.Honest question, the 1-71 I just acquired has good compression, rolls over smooth and the tank is clean and shiny inside. Do i rebuild...
-
lehman live edge slab reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Bottom line of the coil & flywheel testing: Points ignition (Mini Mac) uses "IGN" flywheel 91961/94513/94737,217673 Early brown &... -
lehman live edge slab reacted to Fleethirte's post in the thread Stihl MS881! The rumors begin with Like.
We found it twice, third time it was gone lol I was thinking of welding it and then grinding it flush but…. Actually i can find a small...
-
lehman live edge slab replied to the thread Stihl MS881! The rumors begin.If they had both pieces they probably could silver solder them back together though i suppose it’s unlikely they do the one probably...
-
lehman live edge slab reacted to huskihl's post in the thread Stihl MS881! The rumors begin with Like.
It’s pressed in and I believe it’s furnace brazed or fusion welded (or something like that 🤷🏽♂️) on the backside. Bottom line, you need...
-
lehman live edge slab reacted to hacskaroly's post in the thread is STIHL the only one doing 4-mix and how does that make more power than 2-stroke? with Like.
I had a friend bring over his FS90, runs great for about 3-4 minutes and then dies out. Tested the valves and they were loose. Adjusted...
-
Well I’m back to logging for the season. I’ve been running my 20” bar a lot lately, and the Duke’s chains I have are for my 25” bar...
-
It's a lot easier on the pawls for sure and a good practice,but the 572xp pulley is the same part as in a 562xp and the 550xp. It really...
-
lehman live edge slab reacted to Bill G's post in the thread WANTED Allis Chalmers branded saws with Like.
This one is still pumping.
-
lehman live edge slab replied to the thread The 572XP Update Thread.This was not my intention, I just mentioned one guy with an issue and the dealership/husky so far hasn’t been able to make it work right...
-
lehman live edge slab replied to the thread The 572XP Update Thread.Yes the 462 had issues when got some hours on them there was a chance the piston would hit the diverter in case and break the skirt...
-
lehman live edge slab replied to the thread The 572XP Update Thread.Not 15, but yes did do a redesign to save a little weight but not really because of running issues. Slanted fins for better cooling and...
-
lehman live edge slab replied to the thread The 572XP Update Thread.100% never said junk just that they don’t all seem to perform to expectations that’s all. Stihls don’t either but do seem to have less...
-
lehman live edge slab replied to the thread Remington.It’s 3/8”