huskihl's latest activity
-
huskihl reacted to davidwyby's post in the thread Buyer/seller reference check: davidwyby with
Like.
Thanks @MG2186 @huskihl @cuinrearview @Stump Shot @jacktheripper @JimG. @Jusgunn3 @Woodslasher @Flying_Dutchman @IffykidMn @bradb123... -
Well, a free cake isn't bad! LOL
-
Went to finish cutting up the 5’ uproot and ended up being under chained. Dead stuff and dirty, lots of sharpening. 32” FC FC stihl...
-
I thought he said a new carb fixed the two that had sat and were running poorly. I may have missed it though, that was a lot.
-
Is intake boot folded?
-
huskihl replied to the thread Stihl 261c blowing out spark plugs.I believe it’s from loose plugs that don’t completely crush the washer. Vibration allows it to loosen up. Only decomp I’ve seen stripped...
-
huskihl replied to the thread HELP! 372 xtorq issues.So in the end, it idles erratically? What color is the coil?
-
Decent 365 only non oem parts are clutch cover and high top conversion I have the oem low top system haven’t taken a compression test...
-
How often do you fellas go to Antarctica?
-
That's almost like asking about the availability of Astro-Glide in Antarctica.
-
This site may need ads as income to cover expenses. The issue is Google is getting stinky rich selling ads, while sites like this that...
-
Got the new nozzle, installed it in carb and saw is up and running again!
-
It think this is just a way to isolate the cylinder side from the carb side. The rubber is tough, but will give way to the scrench if...
