huskihl's latest activity
-
huskihl reacted to Junk Meister's post in the thread 372 sputters when tipped, passes spray test with
Like.
THANK YOU I wasn't even close to your explanation. -
huskihl reacted to davidwyby's post in the thread 372 sputters when tipped, passes spray test with Like.
Flexible, intermittent annoying confusing obnoxious
-
huskihl replied to the thread 372 sputters when tipped, passes spray test.Flexible, meaning something that can change size depending on throttle position. There’s vacuum inside the crank case and intake boot...
-
huskihl reacted to Squish9's post in the thread HELP! How to know when you have too much hook with Like.
That will cut OK. You can adjust things to suit the power and wood type you are cutting. A cutter like that will allow a little more...
-
huskihl reacted to davidwyby's post in the thread 372 sputters when tipped, passes spray test with Like.
I swapped the carb to a 385 carb off my smashed XS 2175 this am and I haven’t put a bar on and put it in wood yet but the tune is stable...
-
huskihl reacted to Woodslasher's post in the thread 372 sputters when tipped, passes spray test with Like.
Out of 5 or more 372-chassis saws I've stripped only 1 had an o-ring present and none of the ones without it exhibited any sort of...
-
huskihl replied to the thread 372 sputters when tipped, passes spray test.Something else I’ve learned along the way. If your carb screws are normally at one and one, turn the H out 2 turns. Hold the saw wide...
-
medium size bonfire: engage!
-
huskihl replied to the thread 372 sputters when tipped, passes spray test.026 failing the tip test is more likely fuel pooling in the intake and in the lower transfer ports. L screw needs to be leaned out a...
-
huskihl reacted to tree monkey's post in the thread 372 sputters when tipped, passes spray test with Like.
put a carb kit in it
-
I expect to head up to Grayling on Thurs. & over to Frankfort Fri. AM.
-
Nice! That sure beats milling with a chainsaw!
-
huskihl replied to the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421.I have actually never done a vacuum test where I couldn’t hold out on the dcomp and not be able to seal it up. I could see where carbon...
-
huskihl reacted to hacskaroly's post in the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421 with Like.
Yes, you should be able to do that, if it still leaks, then there might be something (carbon) between the decomp and its socket that...
-
huskihl replied to the thread 372 sputters when tipped, passes spray test.Might be able to remove the clutch, worm gear, oil pump off PTO side and pull the bushing and see if the bearing retainer is still in...