hacskaroly's latest activity
-
Clone… -
I like the 550 and 572…I have tried to like the 562, but the MK I’s always seemed to be on the verge of crank bearing failure, and I...
-
hacskaroly replied to the thread The Swap Meet Thread.There's another one of you out there??? 🤣
-
There's no need to run that one in the older models - the older saws (pre-2018) had more carburetor issues than anything...
-
It's like they're not even trying.
-
Damn that’s wild!! What oils ratio you run$$ I wonder if it’s because it’s a 4-mix motor??? I just pulled an exhaust off my 261...
-
Well, p&v passed, carb passed...hmm... No air leaks Has to be some sort of fuel delivery issue. Vapor lock? I filled the tank about half...
-
Shindaiwa 360 that got a complete rebuild. Has had fuel issues ever since. Idles fine, cuts great. But, jostle around and it dies...
-
Picked up a nice 034 today needs a fuel line guy said it runs funny,, filter was in tank bottom so i guess it was gulping air,,,
-
Port the Echo. You have a backup for that one if you botch it. Start with a muffler mod and some timing advance. From there you may...
-
hacskaroly replied to the thread HELP! Husky 562 stuffers?!?!.I got a 545 for $25...I think I overpaid 🤣
-
The pop-up pistons on eBay are mostly LRB or Farmertec and my experience with those is they're not a tight enough fit to the cylinder...
-
Mitch Weber stopped by today, he's in the process of reworking his shop and needed to get some stuff out of the way. I think I can...
-
I ordered parts to repair the J3816 (brake handle, rear trigger handle) but unfortunately the rear handle was also broken when it...
-
Well, I was just told that both of my saws are considered homeowner saws and there's nothing much that an be done with them. I only...
