hacskaroly's latest activity
-
Sense of humor much? I've owned a couple of 4 series saws. Both were free. I stand by my statement that he over paid. Both as a joke... -
8am this morning, only about 90° Fahrenheit .
-
Wow, that's a heck of a deal! When I first bought my land, that's what i started out with, along with an old 42 cc craftsman and a ms...
-
hacskaroly reacted to Squareground3691's post in the thread MCCULLOCH The official McCulloch thread with
Like.
-
Around 25 years ago I bought a XL-12/SXL brush cutter. I ran it for less than 5 minutes and put it in the shed. My Stihl FS550, FS350...
-
I got a hernia just looking at that beast.
-
One of my good friends has a Husky 455. I serviced it once. He loves the saw and uses it all the time. Not cheap: new ones run $600 with...
-
My daily driver is a newer GMC with some fixin's, but I have a $300.00 1989 xj 4x4 and a fairly decent 91 Dakota extended cab v8. Every...
-
hacskaroly reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
If the tapers were clean, dry, and fit well and the clutch nut properly torqued (book says 160-170 In/#) it should be O.K. Since you...
-
hacskaroly replied to the thread Preliminary Carb Settings for New Carb (Stihl 021).I generally do 1 and 1 too and then quarter turn increments after that as needed to get it running good!
-
hacskaroly reacted to hotajax's post in the thread Preliminary Carb Settings for New Carb (Stihl 021) with Like.
Turn the screws out 1 full turn? 1 1/2 turns? Thanks.
-
hacskaroly reacted to Outback's post in the thread Preliminary Carb Settings for New Carb (Stihl 021) with Like.
My cheat sheet says 1 on the low and the high is fixed. If you carb has H and L I would do 1 and 1.
-
You overpaid.
-
When it gets hot and dies, pull the plug. If its wet, its flooding. If its dry, ground the plug to the cylinder and see if you have...
-
Anyone make or use a crooked knife for carving? I see ‘hoof knives’ for sale, for under $20. ‘Crooked knives’ seem to go for $100+ (!)...
