Recent content by Fleethirte
-
-
395xp cylinder identification
i say it’s a steal. worse case you throw a 100 oem carb on it and your in 400 for a 395 all oem!!- Fleethirte
- Post #6
- Forum: Technical Area
-
Any Chinese chainsaw and chinese parts discussion
mine oil very well. i also heard that they usually oil good. i know the 660 and 288 kits usually have sand and grit in the pumps.- Fleethirte
- Post #2,718
- Forum: Chainsaws
-
What? No bandsaw milling threads?
oh wow! i’m sure that knot didn’t help- Fleethirte
- Post #499
- Forum: Milling
-
Any Chinese chainsaw and chinese parts discussion
aren’t the 372 notorious for large amount of squish?- Fleethirte
- Post #2,711
- Forum: Chainsaws
-
What? No bandsaw milling threads?
yes it looks good, i will cut it at 10 feet and see how it looks- Fleethirte
- Post #497
- Forum: Milling
-
-
-
What? No bandsaw milling threads?
should i cut further up or will that be ok? it’s solid…🤷- Fleethirte
- Post #491
- Forum: Milling
-
What? No bandsaw milling threads?
how far up you think that hole goes? i didn’t think that tree had this issue till i started cutting it….- Fleethirte
- Post #489
- Forum: Milling
-
395 piston pin
i don’t see the part number for a 395 piston wrist pin. the needle bearing has one, but not the wrist pin? anyone know what it is? actually i don’t even see it in the ipl….- Fleethirte
- Thread
- Replies: 4
- Forum: Chainsaws
-
-
What? No bandsaw milling threads?
white oak? how wide can your saw cut?- Fleethirte
- Post #470
- Forum: Milling
-
What? No bandsaw milling threads?
touche, i remember my dad cutting a willow tree when i was a kid. he said it was the second time he cut it down….- Fleethirte
- Post #469
- Forum: Milling
-
What? No bandsaw milling threads?
wow that tree remembered you and i now feel young- Fleethirte
- Post #464
- Forum: Milling