MS 271 carb limiters

[redtractor]

What fresh hell is this and how do I eliminate it? I tried prying up to a point. Don't want to break a customers saw. Besides, anything small enough to get in there was weak enough to bend. And to really piss me off, they're spinning

 

[MustangMike]

Never saw anything like that before, and I'm glad about that! Thought the MS250 was tough, but I just filed it and used my razor knife and got it to move enough.

 

[DND 9000]

You need the Puller (M3 left-hand thread) part no.: 5910 890 4502. Line up the notch on the cap with the top of the carb and pull it out. (Screw puller about 5 turns counterclockwise in and pull.) For adjusting the H screw you need a 2mm hex screwdriver part no.: 5910 890 2306

As I see from your picture, you need the older version of the limiter cap (1141 121 2702) without guide slot to install after repair.

 

[redtractor]

... you need the older version of the limiter cap ..... to install after repair.

Umm.. I will politely decline, thank you.