kjudd
Well-Known OPE Member
This is my Huztl 660. Phase 1. I built it completely stock parts expect for and HL supply gasket kit. I built with no base gasket and a mild port job on it. Mostly just cleaning and beveling everything. It's cut about 3 cords of wood so far and has milled for about an hour.
This is where phase 2 comes in. This saw mills better and runs better them my BB stihl 660. So for phase 2 I'm swapping PC for a Cross MMWS PC with no base gasket. And the Stihl 660 is getting it OEM cylinder with a hyway piston and no base gasket with a mild port/cleaning job.
And then I will set out to mill some lumber and see which I like better.
Sent from my SAMSUNG-SM-G890A using Tapatalk
This is where phase 2 comes in. This saw mills better and runs better them my BB stihl 660. So for phase 2 I'm swapping PC for a Cross MMWS PC with no base gasket. And the Stihl 660 is getting it OEM cylinder with a hyway piston and no base gasket with a mild port/cleaning job.
And then I will set out to mill some lumber and see which I like better.
Sent from my SAMSUNG-SM-G890A using Tapatalk