- Local time
- 5:25 PM
- User ID
- 522
- Joined
- Jan 12, 2016
- Messages
- 3,946
- Reaction score
- 26,016
- Location
- Iowa City
I just finished a couple of 562's and I was comparing them to my old EL44 carb work horse when I decided to try advancing the ignition timing. I was always under the impression that these saws really didn't need more timing and I was always a little skeptical of how the autotune would deal with it. The cut times don't lie, they were faster because I could push on the work chain much harder.
It did take a few throttle blips before the autotune had the throttle response back and it took a few cuts before they behaved. Even with older flashes they figured them selves out pretty quickly.
I ported both saws with very similar numbers.
It did take a few throttle blips before the autotune had the throttle response back and it took a few cuts before they behaved. Even with older flashes they figured them selves out pretty quickly.
I ported both saws with very similar numbers.