WANTED Husqvarna 2100CD Flywheel Found

[northwest saws]

Hello all, as the title states I am in need of a good flywheel for the old 2100 CD. This has the electronic sem coil. If anyone has one they would like to sell give me a shout. Thanks

Sent from my SM-N970U using Tapatalk

Sent from my SM-N970U using Tapatalk

 

[Stump Shot]

Just went through my treasure pile and came up with three older FEMSA units.
Might be @EvilRoySlade has one by chance.

 

[Gaston]

I may have one. I will dig it out tomorrow. I am not sure if it’s a sem or not.

 

[northwest saws]

Thanks. Here's the one I have and the part no. on it if that helps.

Sent from my SM-N970U using Tapatalk

 

[Pdotsaws]

I have some.

 

[EvilRoySlade]

@northwest saws I'll send you a PM. I have a guy in Kalispell, MT that always has 2100 showing up. Might be good for you guys to meet anyway being in the same region.

 

[Gaston]

Well I found the flywheel. It’s 5018322, which I believe is the updated number for the flywheel you have. Only problem is all the pins and starter paws are gone.

 

[northwest saws]

Well I found the flywheel. It’s 5018322, which I believe is the updated number for the flywheel you have. Only problem is all the pins and starter paws are gone. View attachment 330381

No biggie, I can just swap the pawls from the flywheel I have to the other. Sent you a pm.

Sent from my SM-N970U using Tapatalk

 

[northwest saws]

@northwest saws I'll send you a PM. I have a guy in Kalispell, MT that always has 2100 showing up. Might be good for you guys to meet anyway being in the same region.

Sounds good. Always looking to get to know other saw folks and where to get parts.

Sent from my SM-N970U using Tapatalk

 

[srcarr52]

Side note, if the holes in the flywheel are too loose for the press fit pins I've heli-coiled the holes to M5 and used 288 style screw in pins instead.

 

[northwest saws]

Excellent nugget of info there thanks!

Sent from my SM-N970U using Tapatalk