Echo epa carb screw driver

[smokey7]

Got handheld blower here and its got super small carb screws for h&l please let me know wad drivers I have to order.

 

[RI Chevy]

How small us small? Eye glass screw small?

 

[1990Husky262]

your probley talking about one with the carb like on a pb-250 with the two super small d screws. As far as i have been able to find there is no aftermarket available for those. I even tried to order on through my dealer ( witch had no problem doing it) and they were unable to get it on a normal parts order. I did read some where that you can take the high speed nozzle out of an old Briggs up draft like on an 8 or 10 hp and dent the end of it and use that as a tool but i have yet needed to try it.

 

[TALLGUY]

Try an 1/8" spring roll pin. I was able to move the screw just enough to get a blower to run correct using the roll pin. May have to modify the end a bit.

Sent from my SM-G900V using Tapatalk

 

[smokey7]

I need to look closer with a light. But they are tiny. Good to know they are unavailable. ..... And thanks also for some workarounds to deal with it. If anyone finds out where and how to get the tool because I'd love to buy one or a addon to my set i already got.

 

[t4driller]

I've also used electrical fitting ends to adjust those.

like these. I think the red ones fit the normal size needles.

 

[166]

You're looking for a Micro D driver. They are hard to find.

 

[ANewSawyer]

Link is isn't working replace the dot with a . In the amazon address.
I believe this is what you are looking for.

https://www.amazondotcom/Paxcoo-Car...pcs+carburetor+adjusting+tool+with+case&psc=1

 

[RI Chevy]

Link not working

 

[backhoelover]

your probley talking about one with the carb like on a pb-250 with the two super small d screws. As far as i have been able to find there is no aftermarket available for those. I even tried to order on through my dealer ( witch had no problem doing it) and they were unable to get it on a normal parts order. I did read some where that you can take the high speed nozzle out of an old Briggs up draft like on an 8 or 10 hp and dent the end of it and use that as a tool but i have yet needed to try it.

that was me on the nozzle

 

[backhoelover]

http://www.arboristsite.com/community/threads/homemade-small-single-d-carb-tool.288369/

 

[ANewSawyer]

Link not working

I put in text because it is overwriting my copied link with an ad for amazon. Just go there and search for paxcoo 8pc carb set or something like it. Credit goes to backhoelover anyway!

 

[backhoelover]

there is a 8 piece set on ebay

 

[backhoelover]

here is update on small d carb tool. they had to make some changes for walbor new carb

 

[backhoelover]

here is pic of tool catalog small d is in there

 

[1990Husky262]

just ordered a set from amazon. Thanks for the tip

 

[RI Chevy]

Cool. Thanks for the info.

 

[smokey7]

Thanks so much guys I really appreciate it.