Dustin4185
Pinnacle OPE Member
- Local time
- 7:32 PM
- User ID
- 2032
- Joined
- Oct 25, 2016
- Messages
- 1,300
- Reaction score
- 3,695
- Location
- East TN
Welllllll, I think I may have an issue with my MMWS 461. We were doing some saw training/road daylighting with a group of sawyers on a WMA. While taking a break, my supervisor grabbed my saw and started cutting. Generally, no big deal, he is pretty experienced, I gassed it up with my mix, and it wasn’t anything sketchy. Anyway, he was bucking some pines in the road and misread the bind. He jerked pretty quick and got it out before it really bound up. After that, it sounded like it didn’t want to idle, then it would idle fast, then it would die. I started it and it went from normal idle to fast idle without me touching the throttle and I immediately shut it down and put it in the tool box.
After getting up at 4AM to drive three hours to get there. Sawing until 4:30P, driving three hours home, I am whooped and didn’t have time to look at it.
Where do I start? Check the intake boot? Seals? Re-tune? I did have to adjust the carb some since we were about 3,000 feet above where I normally operate. I DO NOT have a Mighty Vac. I assume it is something simple, but definitely don’t want to burn it up. This is a fairly low hour saw. I asked him how hard he pulled and he said “not too hard, I knew we had other saws”. He is typically good about not jerking and pulling on saws unlike some other agency employees, lol.
After getting up at 4AM to drive three hours to get there. Sawing until 4:30P, driving three hours home, I am whooped and didn’t have time to look at it.
Where do I start? Check the intake boot? Seals? Re-tune? I did have to adjust the carb some since we were about 3,000 feet above where I normally operate. I DO NOT have a Mighty Vac. I assume it is something simple, but definitely don’t want to burn it up. This is a fairly low hour saw. I asked him how hard he pulled and he said “not too hard, I knew we had other saws”. He is typically good about not jerking and pulling on saws unlike some other agency employees, lol.