brandonstclair20
Pinnacle OPE Member
- Local time
- 4:42 PM
- User ID
- 2159
- Joined
- Nov 21, 2016
- Messages
- 940
- Reaction score
- 2,636
- Location
- Starkville
Stihl 066, a while back, I installed a new oem clutch side bearing, a 6203 c3 nachi quest bearing for the flywheel side. I also replaced the gaskets, seals and air filter cover, those are also oem. I replaced the impulse line and the upper fuel line, impulse line is oem. The saw has a very nice ms650 Cylinder and a new oem piston, wrist pin bearing, rings and clips. I first tried a new aftermarket (Chinese) carburetor on it and it would run but wouldn’t rev up, no matter how I adjusted it. I then took a used carburetor and rebuilt it. Then the saw wouldn’t run. Then I tried a brand new Tillotson carburetor on it. It still wouldn’t run. The saw does have the dual keyway flywheel on it. I don’t need a saw this big and I’m tired of fooling with it. I’m sure with a little tinkering you can get it going. $400 plus shipping.
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk