Big bore and stroked Husky 395 build.

[Wolverine]

 

[Jimmy in NC]

I'm out of pictures so we'll just cut to the video of it running. It was a rough day trying to get to testing. I ran 3 different coils before I found a suitable one. I still think this one may be loosing sparks at high RPM but it wasn't as noticeable as others with the timing light. I have a known good coil that I can pull off my other 395 some other day. With the timing light on the saw I also noticed the china 394/395 coils are much different timing than an OEM, not a good deal.

So stick to OEM coils on these...interesting.

Sent from my SM-G920V using Tapatalk

 

[Wolverine]

So stick to OEM coils on these...interesting.

Sent from my SM-G920V using Tapatalk

Definitely. I went through a cheena one in a few short months and it didn't feel as stout, which explains timing statement.

 

[srcarr52]

So stick to OEM coils on these...interesting.

Sent from my SM-G920V using Tapatalk

I think you'd be fine if you advance the flywheel a whole vane. I think I've used one in the past, now I want to get that saw back and fix it.

 

[Lee H]

Nice build Shawn, Very creative.

 

[RIDE-RED 350r]

Now THAT is some nice work my friend! Very cool

 

[Mastermind]

How can I get one of those cranks?

 

[Wendell]

Damn beggars.

 

[jacob j.]

Damn beggars.

I want one too...

 

[Adirondackstihl]

Awesomeness!!

 

[cgraham1]

Can you put one in a 288xp? I think the 394xp uses the same crank as a 288xp...

 

[cgraham1]

How can I get one of those cranks?

Here ya go.

 

[Wendell]

I want one too...

Well, that's different. LOL

 

[srcarr52]

Can you put one in a 288xp? I think the 394xp uses the same crank as a 288xp...

Now we're thinking!

 

[Deets066]

How can I get one of those cranks?

Call Falicon, only should be about $600

 

[Mastermind]

Damn beggars.

Don't make me get @Jon1212 to ban you.

Call Falicon, only should be about $600

Well. So helpful.

 

[srcarr52]

How can I get one of those cranks?

Find a 2100 crank... machine it on your lathe. Bam! You have a crank.

 

[Mastermind]

Find a 2100 crank... machine it on your lathe. Bam! You have a crank.

I'm not a great machinist. Getting the taper right would be tough. Also, I'm not sure my lathe is rigid enough to cut through the layer of hardened material.

 

[Deets066]

I'm not a great machinist. Getting the taper right would be tough. Also, I'm not sure my lathe is rigid enough to cut through the layer of hardened material.

I bet you could with the right tooling and light cuts

 

[Tractorsaw1]

Thanks for sharing and enlightening me - this was similar to what I was thinking when I asked about the 066 crank in the 2083 build