Chainsaw Jim
Con Artist LLC
- Local time
- 7:48 PM
- User ID
- 836
- Joined
- Feb 8, 2016
- Messages
- 4,014
- Reaction score
- 79
- Location
- Springfield Oregon
Here's a side burner project I've been stabbing at once every other blue moon or so. The intake needed enlarged a little to fit a larger boot.
It had been running the 1128 series intake boot, but it was collapsing in the middle from the awkward angle.
The 1122 series boot is a much better fit, but the clamp end is just a bit too large.
To remedy that, I used a piece of plastic tube to build mold.
I glued it to the cylinder..
Then filled with regular JB weld.
I'll let that cure for a few days or however long it'll be before I can get back to it.
It had been running the 1128 series intake boot, but it was collapsing in the middle from the awkward angle.
The 1122 series boot is a much better fit, but the clamp end is just a bit too large.
To remedy that, I used a piece of plastic tube to build mold.
I glued it to the cylinder..
Then filled with regular JB weld.
I'll let that cure for a few days or however long it'll be before I can get back to it.