You Ham Fisted Nut !

[Gary Courtney]

Well ! I ran my 500i yesterday after a fresh build and I am really suprised. Was cleaning it up today and for some stupid thought I decided to check my case bolts and i'll be a monkies uncle I broke the first one I touched with my ham fisted A**. had to tear it down and remove it then replace it. Why aluminum bolts?

 

[Outback]

Same reason you have torque to yield in your car. Just replace with steel. The couple of grams aren't going to matter.

 

[EFSM]

Well ! I ran my 500i yesterday after a fresh build and I am really suprised. Was cleaning it up today and for some stupid thought I decided to check my case bolts and i'll be a monkies uncle I broke the first one I touched with my ham fisted A**. had to tear it down and remove it then replace it. Why aluminum bolts?

My understanding is that Husqvarna and Stihl are both doing it for weight savings. It seems to me that there is somewhere better to cut the weight of a paper clip.

 

[Gary Courtney]

My understanding is that Husqvarna and Stihl are both doing it for weight savings. It seems to me that there is somewhere better to cut the weight of a paper clip.

I looked in my 5mm Sihl screws and could not find any steel screws. I sure hope if I have to take it back apartin the future they do not snap

 

[legdelimber]

Anyone running a screw machine? What's tooling life of rolling threads and mashing the heads on steel vs aluminum?
What about lubricants?
How well does the machine stay in adjustment?
Does the electric bill drop off enough to count against the cost of the aluminum stock over steel?
I've never touched a screw machine, but have worked in a shop that had several.
Older machines of course. Bunch of cams and linkages and clatter and splattering.
The guy that ran them (piece work) seemed to constantly walk back and forth to keep something going.

 

[Brad Button]

Use a 1/4 drive torque wrench next time and tighten to Stihl's specs.

 

[Gary Courtney]

Use a 1/4 drive torque wrench next time and tighten to Stihl's specs.

You are correct. I had one but it must be out of calibration as the last saw I used it on was set for specs and snapped one off so I have laid it to the side and as thread title states!

 

[Mad Professor]

You are correct. I had one but it must be out of calibration as the last saw I used it on was set for specs and snapped one off so I have laid it to the side and as thread title states!

I'd replace them ALL with steel cap screws. Any good hardware store......