Windsor Bar Mount MCH

[~Yellow Streak~]

Any ideas? I bought a few of these. Would like to know if anybody can ID the mount?
Don't see nothing like this in Oregon mounts, nor in the Windsor literature I found.
Hopefully they will be something I can at least adapt.... like, to Mac

 

[Spladle160]

What does the bar itself say? MHC or MCH?

 

[~Yellow Streak~]

I 'm waiting to receive them. I'll post back when I do. I figured I'd take a chance on adapting them and if I could figure out the mount, sell one (or all, if I can't adapt them to Mac 610 or Stihl medium mount) to recoup some $.

 

[SimonHS]

Windsor MC mount is McCulloch with a 0.250" wide slot.

Can't find MCH mentioned. You need someone with an old Windsor bar catalog to look up that code.

 

[~Yellow Streak~]

.250 slot would be the consumer bars, like for the Mac PM340 etc. Those bars have an open slot towards the drum sprocket.

 

[~Yellow Streak~]

Well. the number on the bars are 16MCH50LYA. The slots are 8mm, like the D176 mount. Gonna go out here and get at one of the bar plates on my 600 series Macs. ~ .o50 fits snug.

 

[~Yellow Streak~]

BINGO ... and NOT bingo. Everything looks good except the bars are slightly longer than a Mac 16" bar. Put a 60DL chain on one and there's only 6 DL's off the tail. On the Mac branded bar, there's 7 DL's off the tail. Did a "not so thorough" search of thebay and all I found in 61DL or even 62DL was Lo Pro. I'm all the time puttin odd ball items in my "Chainsaw" folder on thebay. I'll have to go look.

I'm not versed in building loops, nor do I have the equipment/supplies. Eventually, I'd like to tinker with that.

I do like the way the bars are designed. The oil hole Y's out toward the bar groove (yellow in pic).

For $13.80 each shipped, I can't complain too much.