Welcome To The 12 Saws Of Christmas

[Redfin]

Who's got their saws done?

I'm looking at doing a 036 with a 044 top end.

Thats not 60ish cc. Just sayin

Course your idea of ish may be different than mine.

 

[Mastermind]

With the stroke being shorter.......what would it be?

 

[Redfin]

With the stroke being shorter.......what would it be?

*pretty boy friday, forgot about stroke. My sorry.

 

[paragonbuilder]

Thats not 60ish cc. Just sayin

Course your idea of ish may be different than mine.

I was thinking the same thing [emoji849].
So with shorter stroke what is it Randy?


Sent from my iPhone using Tapatalk

 

[Redfin]

I was thinking the same thing [emoji849].
So with shorter stroke what is it Randy?


Sent from my iPhone using Tapatalk

I was thinkin they were same stroke. At 34 and 50 its about 66.

 

[junkman]

Who's got their saws done?

I'm looking at doing a 036 with a 044 top end.

I have been wondering if this was possible for years ,early 10mm piston i assume ?

 

[paragonbuilder]

I was thinkin they were same stroke. At 34 and 50 its about 66.

How is that figured. Just a simple volume calc?


Sent from my iPhone using Tapatalk

 

[Mastermind]

 

[Mastermind]

The base ends up pretty thin......and that's without compression work. I need a 10mm pin piston with a taller crown height.

 

[huskihl]

Makes it pretty much an 038 super. And i bet a whole lot lighter one at that

 

[Redfin]

The base ends up pretty thin......and that's without compression work. I need a 10mm pin piston with a taller crown height.

Whats the pin on a 372?

 

[Mastermind]

12mm....

I'm looking at a 266 or 268 piston with brass pin bushings.

 

[huskihl]

The base ends up pretty thin......and that's without compression work. I need a 10mm pin piston with a taller crown height.

Can you work around the wrist pin diameter? Everything I see in 50mm is 12mm other than 044

 

[junkman]

what size pins are on 038 or 042 saws ?

 

[Redfin]

Can you work around the wrist pin diameter? Everything I see in 50mm is 12mm other than 044

Where are you looking for this info?

 

[huskihl]

Where are you looking for this info?

Meteor's website

 

[Mastermind]

I can make brass bushings that go in the piston to adapt a 12mm piston to a 10mm pin.

 

[Redfin]

Meteor's website

Thanks man.

 

[Mastermind]

You just make the bushings like a cap that goes over the ends of the pin. That way the bushing holds the pin, and the circlip holds the bushing. Of course you still drill a hole in the center of the bushing to lighten it. Does this make sense?

 

[hseII]

Who's got their saws done?

I'm looking at doing a 036 with a 044 top end.

Yes Please.