Tillotson HK service manual

[Majorpayne]

I am looking for a service manual for Tillotson HK carbs. Thanks

 

[ray benson]

I am looking for a service manual for Tillotson HK carbs. Thanks

Check your inbox

 

[trooney]

@ray benson I need a copy of that also. Got a Super 2 and I want to make sure the metering lever assembly so I dont mess anyting up. Thanks in advance Ray!

 

[ray benson]

@ray benson I need a copy of that also. Got a Super 2 and I want to make sure the metering lever assembly so I dont mess anyting up. Thanks in advance Ray!

Check your inbox

 

[Sawponder]

Check your inbox

May i also have a copy of the hk manual

 

[ray benson]

May i also have a copy of the hk manual

Check your inbox.

 

[Mathias]

Check your inbox.

May i also have a copy of the hk manual?

 

[ray benson]

May i also have a copy of the hk manual?

Check your inbox.

 

[Al Smith]

This may or may not be of interest .At one time Abbott and Foran of Decatur Indiana published manuals for Tillotson phone number was 217-877-4491 . Weather this applies these days I have no idea or they might have down loads by now .You might try Googling it .

 

[ray benson]

This may or may not be of interest .At one time Abbott and Foran of Decatur Indiana published manuals for Tillotson phone number was 217-877-4491 . Weather this applies these days I have no idea or they might have down loads by now .You might try Googling it .

I see the that catalog (1989) priced from $50 to $125. Will look later to see if anyone scanned it.

 

[Al Smith]

I see the that catalog (1989) priced from $50 to $125. Will look later to see if anyone scanned it.

I found it on E-bay a long time ago.15-20 bucks .These days I certainly think it would have been in electronic formate some place .I think however for those seeking info they could go right to Tillotson web site and find the info .Many are not aware Tilley ,Walbro and Zama all have web sites .There is a lot of info on the internet you just have to learn how to find it .

 

[Al Smith]

I did take a few minutes to search the net for manuals and in 5 minutes found a lot .Some can be copied some are just for sale and as typical prices can be all over the place
Carbs can be interesting and often frustrating .Some times you just have to walk away from them for a little bit .My best rework was either a Walbro or a Tillotson used on a McCulloch 6-10 which is just a larger version of the old classic 10-10 .Not to be confuised with PM 610 cinder block .By using the parts of three different carbs I came up with one by using the choke side as being much larger than the throttle side thus performing like Vee stack at higher speeds .That little saw 70 cc will dead throttle at over 15,000 RPM's .Some times you get lucky some times not .I might add that old Mac is just a toy I seldom use because running that fast it would destroy itself after a period of time.