Post up your ported cylinder Artwork

[Chainsaw Jim]

Ms440 cylinder.

 

[Fruecrue]

Love that exhaust port roof Jim.

 

[Mastermind]

Ported saws? How silly.

 

[srcarr52]

Husky 2101

 

[cus_deluxe]

Husky 2101

View attachment 134357 View attachment 134358 View attachment 134359 View attachment 134360 View attachment 134361

That intake looks rad.

 

[Deets066]

I think my foot would fit in the lower trans....

 

[MG porting]

I think my foot would fit in the lower trans....

I'm going out of my way to to say that thing is going to scream lol

 

[drf256]

Husky 2101

View attachment 134357 View attachment 134358 View attachment 134359 View attachment 134360 View attachment 134361

Very nicely done

 

[srcarr52]

I'm going out of my way to to say that thing is going to scream lol

It runs ok.

 

[huskyboy]

It runs ok.

What kinda rpm is it holding in the wood? Sounds real good... like 10.5-11k in the wood.

 

[srcarr52]

What kinda rpm is it holding in the wood? Sounds real good... like 10.5-11k in the wood.

Yup, right around 11k.

 

[MG porting]

It runs ok.

Very nice indeed.

 

[MG porting]

Well here's another farmertec 660 cylinder I just finished up with this morning before it gets to hot out.

 

[Fruecrue]

Well here's another farmertec 660 cylinder I just finished up with this morning before it gets to hot out.

Looking good!
Care to share the timing #s?

 

[MG porting]

Looking good!
Care to share the timing #s?

Thanks. And lol for making me go back out in the garage in this blazing heat. Not all of them turn out like this but here are the numbers I got out of this one and I normally don't share numbers so I guess it's time that I did. But just don't expect it to happen all the time. just funnen with you. Lol.

 

[Fruecrue]

Thanks. And lol for making me go back out in the garage in this blazing heat. Not all of them turn out like this but here are the numbers I got out of this one and I normally don't share numbers so I guess it's time that I did. But just don't expect it to happen all the time. just funnen with you. Lol.

Tl;Dr
#s?

 

[MG porting]

Looking good!
Care to share the timing #s?

I guess it would help if I finished my reply Lol I'm a spaz I'll admit it. With farmertec piston upper transfers are 121 intake is 76 exhaust is 100 with no base gasket has . 018 squish.

 

[brshephard]

I guess it would help if I finished my reply Lol I'm a spaz I'll admit it. With farmertec piston upper transfers are 121 intake is 76 exhaust is 100 with no base gasket has . 018 squish.

What where your original numbers?

 

[Chainsaw Jim]

It isn't mine, but wow!

 

[jacob j.]

Any time anyone advertises "bad ass power", I steer clear.