porting a 064 hybrid.

[Hedgerow]

I decided that the first time I ported a 395XP.

Perspective...

It can be bittersweet at times...

 

[Mastermind]

But it's always illuminating.

 

[jmssaws]

I have a sporty 394 and 395,trying to beat one of them with a 066 that's still got all its factory parts it's difficult. I beat the 95 once with a 36" but never tried it again. Lol

There's no chance of beating the 94 at any length,orange Devils they are.

 

[Moparmyway]

I have a sporty 394 and 395,trying to beat one of them with a 066 that's still got all its factory parts it's difficult. I beat the 95 once with a 36" but never tried it again. Lol

There's no chance of beating the 94 at any length,orange Devils they are.

The 95 wont beat the 94 after its ported ?

 

[jmssaws]

Both are ported but the 94 is much farther.

 

[Deets066]

I bet the 95 would take it if he pushed it a little farther

 

[jmssaws]

I could go back in and make the 95 faster than the 94 but it's my work saw.

 

[Deets066]

I'm gettin antsy to get my box o 394 together

 

[jmssaws]

The 94 is far enough that it's lost some usability,the 395 is just a good woods port.

 

[drf256]

Is the 94 a quad and the 95 a dual tranny motor?

Damn Husky Jugs, just a better design. As for the rest of the saw, yuck.

J, you ever add fingers to a quad?

 

[Deets066]

Is the 94 a quad and the 95 a dual tranny motor?

Damn Husky Jugs, just a better design. As for the rest of the saw, yuck.

J, you ever add fingers to a quad?

Just the opposite, 94 is dual and 95 is quad

 

[jmssaws]

Nope,never tried fingers in a quad but I'm sure they'd work the same.

I cut 020 from the chamber from the 95 and set it 100 120 78 and it runs just fine at 210lbs. I cut timber with that saw.

 

[Sty57]

I'm gonna make one.......3" in diameter.

I just looked at 3" rod on ebay........holy chit. Pricey.

Have you or anybody else tried using Delrin rod or Nylon for them?

 

[Deets066]

I have seen them made out of pvc, and Somone did make one out of delrin if I remember right

 

[psuiewalsh]

Delrin is neat stuff but may cost more than aluminum unless you can find scrap pieces

Sent from my C771 using Tapatalk 2

 

[Moparmyway]

MSC has 5 foot sections of Type II PVC (2.5 inch diameter) for about $100

 

[jmssaws]

Silly putty is pretty neat too.

 

[Mastermind]

Have you or anybody else tried using Delrin rod or Nylon for them?

I never have........but I've thought about it.

 

[jmssaws]

 

[jmssaws]

That's the best 660 cylinder I've ever checked. No wonder the damn thing runs so good stock.