Oregon grinder stopped working

[Jusgunn3]

Hey gents, have used my grinder in a while and when I went to turn it on it just hums and will not spin. Any ideas?

 

[Duane(Pa)]

You tried flicking the wheel manually?

 

[Jusgunn3]

You tried flicking the wheel manually?

I can move the wheel manually but it does not turn when I turn the motor on.

 

[Duane(Pa)]

I’m talking about “helping” it with the switch turned on…

 

[EFSM]

It could be in the switch, although I don’t know what your setup is. I have an old Foley Belsaw grinder that would just hum but would start spinning if you flicked the wheel. Turned out the switch had two circuits, one of which apparently supplied the capacitors, and that part of the switch had melted. I repaired the melted switching plunger with a fitting from a plastic primer base, which worked for another few years until the switch burned out entirely.

 

[Jusgunn3]

I’m talking about “helping” it with the switch turned on…

I have not tried that, I will give it a go

 

[Duane(Pa)]

I have not tried that, I will give it a go

Carefully…

 

[singinwoodwackr]

Starting cap died?
How old a unit? Might call Ore and see if they will warranty it.