Sounds good. I have straightened one before, but it wasn't bent too badly. I used a large propane weed burner torch to get the whole fork hot and then used a rosebud tip on an oxy/acetylene torch to get the bent area hot enough to work with....not sure if that is the best way to do it, but it seemed to work.
Just checked my notarealhelicoil kit. M5 uses a 5.2mm drill bit.Ay,,, morin Adam ..that’s funny as fork.
You mad bro? You dropped the "the"...
well that forking sucks lol
Duh
Couple weeks of West Viginny power plant shut down training and they'll learn. Marlboros and Folgers in their checked bags and they'll come back pros. You'll promote them to shift supervisor.
lol might be something to that
None here either. Not at all. The folks that have gotten needled get it all the time.
i dont think that really matters
