High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

Not So Pro 3

dall

Mastermind Approved!
Local time
4:55 PM
User ID
795
Joined
Feb 5, 2016
Messages
48,770
Reaction score
201,560
Location
grafton wv
Country flag
Did a thing over the weekend. View attachment 442600
you need a few more up there
Well I unfortunately have no choice, as I log alone. So I always pack 2 saws with me on the skidder. One rides with me in the cab, and the other sits inside the arch, behind the winch. It can’t fall out or get run over. It’s *usually* a very safe place for a saw to ride. This just happened to be an unusual situation. At least it only wrecked the side cover - I can straighten the felling spikes.
still a
dumb ass lol
I worked by myself too😂 can't find anybody that wants to work especially not logging.too much manual labor lazy bass turds
i turned down doing it in 2018 but i didnt do any side work after 2016
True. He is very possessive.
you all are my *b-wordes lol
 

Boomhower

Pinnacle OPE Member
Local time
3:55 PM
User ID
832
Joined
Feb 8, 2016
Messages
1,861
Reaction score
8,639
Location
Houston, TX.
Country flag
A few more years and commiefornia will ban gas saws and everybody will have to go back to cross cuts and axes.there's the real Hitler for you.
Guarantee you Newsom will have illegals in his yard running two stroke leaf blowers when the rest of the state is suffering with batteries.
 

Wonkydonkey

Plastic member
Local time
9:55 PM
User ID
3189
Joined
May 14, 2017
Messages
5,062
Reaction score
22,297
Location
Sussex, UK.
Country flag
Good morning Dudes & not so dudes

I went for a drive yesterday and picked up that ms150t I won on eBay last wk.
A quick check throu the exhaust revealed the piston is good , it had a new s-plug with a big gap 1mm. So I gave it a tap to adjust it.

I fuelled it and ran it, the idle was a bit fast but it idled fine. the acceleration was a bit boggy and it died in the cut if I pushed it.

So I did a quick check of the carb screws and found the H was only just under 1/2 a turn 🤔🤷‍♂️

Once i adjusted it to the limiter 3/4 it ran fine in the 3 or 4 cuts that I did . It’s making me wonder if this place took it in as a part exchange and was just getting rid of it and selling as spares/repairs so there’s no comeback 🧐🤨
IMG_8251.jpegIMG_8252.jpeg
 

nbbt

Mastermind Approved!
GoldMember
Local time
3:55 PM
User ID
12238
Joined
Apr 13, 2020
Messages
3,689
Reaction score
24,585
Location
5543X, 5644X
Good morning folks. Another round of our seasonal temp swings are upon us. 22f this fine Tuesday morning.
Looks like a morning of nearly slacking is going to happen as breakfast/brunch with a group of friends is planned for the earlier portion of this day.
 
Last edited:
Top