High Quality Chainsaw Bars Husqvarna Toys Hockfire Saws

Not So Pro 3

Mastermind

Chief Cat Herder
Staff member
Yearly GoldMember
Local time
4:42 PM
User ID
4
Joined
Dec 3, 2015
Messages
52,596
Reaction score
350,405
Location
Banner Springs Tennessee
Country flag
It's just plain crappy wire Tim. This hasn't seen light of day since it was assembled and that wire is under tape and loom. Whatever mud hut the harnesses are assembled in is where they are getting screwed up.
I blame the Indonesian 12 year olds.
 

JoeDirt

Piss Jug Tosser
Local time
5:42 PM
User ID
12560
Joined
May 11, 2020
Messages
2,631
Reaction score
19,428
Location
United States
Country flag
I made it safe Timmy. Big Red and I are at Yolanda's in Monaca now. Going to Hank's for a little dessert. You ready for some 410 action? @JoeDirt is.
Larson dominated at Las Vegas on Sunday... I'm ready for some High Limit action with the Sharon Speedway slacker gang.
 

beaglebriar

The Peanut Gallery
GoldMember
Local time
5:42 PM
User ID
377
Joined
Jan 1, 2016
Messages
19,430
Reaction score
111,538
Location
Warren Center, PA
Country flag
Of course the wire needs to be broke where the loom is jammed between the frame and cab..

View attachment 410623
The kids truck has dead short in the turn signal circuit. One headlight parted ways with the truck in the crash and pulled the connector off, now it blows the fuse immediately. Does it on both left and right. We ordered a cheap tracer off Amazon I hope it works. It will save a lot of BS I think.
 

redline4

I'm huge in Japan
Local time
4:42 PM
User ID
5593
Joined
Mar 12, 2018
Messages
13,290
Reaction score
112,427
Location
Rosholt Wisconsin
Country flag
I blame the Indonesian 12 year olds.
They are inscrutable.
Wiring can be frustrating especially on can bus circuits. I share Ed's pains.

Sometimes that can be easier though because you can ohm from a module in each direction of the data circuits and you should get the terminating resistor measurement. It at least points a direction.
We have high speed, low speed, the most network is a fućking nightmare at times and used on the infotainment stuff. Local interconnect, etc.. probably same type of data circuits you use.
 

timg

Supporter of Cat Eating Komatsu Machinery
GoldMember
Local time
5:42 PM
User ID
8928
Joined
Mar 7, 2019
Messages
4,432
Reaction score
24,222
Location
Keystone State West
Country flag
They are inscrutable.


Sometimes that can be easier though because you can ohm from a module in each direction of the data circuits and you should get the terminating resistor measurement. It at least points a direction.
We have high speed, low speed, the most network is a fućking nightmare at times and used on the infotainment stuff. Local interconnect, etc.. probably same type of data circuits you use.
Yes, prolly the same high and low circuits with two 120 ohm resistors. Main problem is isolating can circuits between 8-10 controllers. As you have to disconnect each one individually to help isolate a controller, wire,resistor, or multi junction connector melt down. But hey it keeps ya thinking. Just have days where my grey beard is a little more greyer. Had the spell out the grey word for some on here.
 
Top