Lost cause?

[67L36Driver]

Still looking for a loop or length of 9/16" x .078" x 56 drivers for my gear drive Remington.

Random lengths (short or long) will do as I have collected a pile of repair kits.

.078" or .080" gauge. The new drivers measure a half hair over .078".

Loop on the saw now ruined by some idiot filing 50+ degrees.

 

[Wilhelm]

I have a partial roll of Remington chain....did you find a loop?

@Mastermind said to have some, maybe You missed his post.
He did quote You though.

Reground or file Your current loop to desired angles, should still be usable although not very nice for showing.

Good luck with your search!

 

[Mastermind]

@Mastermind said to have some, maybe You missed his post.
He did quote You though.

Reground or file Your current loop to desired angles, should still be usable although not very nice for showing.

Good luck with your search!

I have a smaller chain than Carl is looking for.

 

[Wilhelm]

OK, sorry!
I didn't notice any response from him and thought he might have missed Your post.

 

[Jon1212]

@Bill G @Hedgerow @Lee H

 

[RandyMac]

I might have some in chipper, it was on a 30'' Homelite bar.

 

[67L36Driver]

I might have some in chipper, it was on a 30'' Homelite bar.

Chipper is what's on there.

And yes, we attempted to sharpen it on an Oregon grinder but the results were poor.

 

[67L36Driver]

Before

 

[RandyMac]

1/4'' file should do it.
I have some square bit, it belongs to a McCulloch.

 

[Lee H]

I don't have any of that chain Carl. Never heard of 9/16 in 080 gauge. That's an odd one.

 

[Al Smith]

Dan Henry got into a bunch of oddball old chain a few years back .I haven't seen him online for a couple of years .

 

[Wagnerwerks]

I have 1/4" files....

Dan's supposed to call me, but I haven't heard from him... If he does I'll ask.

 

[cus_deluxe]

Before

Yikes...should be able to salvage something out of that it would seem

 

[67L36Driver]

Yikes...should be able to salvage something out of that it would seem

I've toyed with the idea of just replacing the worst of the cutters. I have five right hand and six left hand in my stash. No where near enuff to rebuild the entire chain.

That and lower the rakers to hell won't have it to make it cut.