- Local time
- 4:42 AM
- User ID
- 232
- Joined
- Dec 24, 2015
- Messages
- 8,939
- Reaction score
- 62,270
- Location
- Coastal Oregon
Hey Guys -
I got a fully rebuilt Jonny 2172 up for grabs. Originally, I set this up for a trade deal with another member but we've since decided to go a different direction. This saw is the result of a low-hour smashed 2172 I got from an AS member on a different trade deal and then a clean 2165 parts saw I got off Ebay. I used the 2165 PTO side case half and the 2172 flywheel side case half (The 2172 PTO side of the case was crunched). I installed new Nachi bearings and new OEM gaskets and seals. I used the 2172 crank because it is flawless. The top end is a new OE 71cc OEM 372/2171 kit that I got from a member here. Carb is the walbro HD-12B and it has a new OEM kit in it. The full-wrap is a used 2171 handle I got from an AS member.
I got a fully rebuilt Jonny 2172 up for grabs. Originally, I set this up for a trade deal with another member but we've since decided to go a different direction. This saw is the result of a low-hour smashed 2172 I got from an AS member on a different trade deal and then a clean 2165 parts saw I got off Ebay. I used the 2165 PTO side case half and the 2172 flywheel side case half (The 2172 PTO side of the case was crunched). I installed new Nachi bearings and new OEM gaskets and seals. I used the 2172 crank because it is flawless. The top end is a new OE 71cc OEM 372/2171 kit that I got from a member here. Carb is the walbro HD-12B and it has a new OEM kit in it. The full-wrap is a used 2171 handle I got from an AS member.
Last edited: